Home
Instruction manual
Detailed description of the start-up and operation of the hardware and the WebUI.
SKM
Updating the SKM
You can update the firmware of the SKM via Spectera WebUI.

Instruction manual
Detailed description of the start-up and operation of the hardware and the WebUI.
- Base Station
- WebUI
  Detailed description of the WebUI navigation and configuration.
- SEK
- SKM
  - Product overview
  - Inserting and removing the rechargeable battery
    The handheld transmitter is powered exclusively by the BA 70 battery (separate accessory).
  - Replace microphone module
    Different microphone modules are available for the handheld transmitter.
  - Attaching the SKM COM
    The SKM COM with the push button adds additional functions to the SKM.
  - Meaning of the LED
    The LED on the bottom of the SKM can display the following information.
  - Switching the SKM on and off
  - Information on the display
    You can view the following information on the SKMs display.
  - Pairing the SKM to the Base Station
  - Using the SKM COM
  - Updating the SKM
    You can update the firmware of the SKM via Spectera WebUI.
- DAD
- CHG 70N-C charger
  The CHG 70N-C is a network enabled charger featuring two individual charging bays.
- L 70 USB charger
- Modular L 6000 charger
  These sections contain information about installing, starting up and operating the modular L 6000 charger and the corresponding charging modules.
- Cleaning and maintenance
  Note the following information when cleaning and maintaining products of the Spectera series.

Updating the SKM

You can update the firmware of the SKM via Spectera WebUI.

All Spectera devices must use the same firmware version. The Base Station determines the firmware version.

NOTICE

Data loss during firmware update

The audio transmission is interrupted during the firmware update of the Base Station, the antenna or the mobile device.

After the firmware update, the device is restarted automatically.

Do not update the firmware during an active live audio transmission.

The remaining battery state must be higher than 10 % to start the update.

To update the firmware:

If you want to update the SKM via Spectera WebUI: Updating the firmware (mobile devices).

The Status LED is flashing green and red during the update.

The firmware has been updated.