Activating location-based mute
You can mute several devices in a room at the same time by using the mute switch on any transmitter.
In order to do so, you must add the device to the mute group for the location.
The following functions are available:
Deactivated
The TC Bar is not part of a mute group. Muting or unmuting does not affect other transmitters.
Part of group
Activate this function to add the TC Bar to a mute group. If one of the transmitters in this mute group is subsequently muted, all other transmitters in the same mute group at the same location will be muted or unmuted at the same time. This is how you can create your own mute group for each location.
If you use the regular mute function via the TC Bar with a routed TCC M, we recommend setting the LED brightness of the TCC M to 0. The mute function can be displayed only on the TC Bar, not on the TCC M.
| CAUTION | |
|---|---|
Danger due to high volume levels
If the TCC M is routed, undesired echoes may occur if Location-based Mute is used during a conference. During muting, the microphone input current is paused, and, accordingly, the AEC cannot always assess the impulse response from the far end.
Avoid using this function in combination with a routed TCC M.
If you use the function, reduce the volume and, if applicable, the microphone amplification before reactivating this function.
| |
To activate the location-based mute function:
- In the Control Cockpit, navigate to .
-
Activate the function Location-based Mute.
The display switches to Part of group.