Detailed description of the start-up and operation of your selected hardware and software product.
Detailed description of the start-up and operation of your selected hardware.
Get your Base Station ready to use in a few steps.
Here you can find general information for your use of the System.
The same or different cards can be installed.
Connect the Base Station to a network for monitoring and controlling.
You can connect up to four antennas to the Base Station.
You can use the internal word clock on the Base Station or connect an external word clock.
You can input and output audio via Dante®.
The filter protects the fans from dust.
You can install the Base Station in any conventional 19" rack. The rack mounting angles are already attached to the device.
You can use the headphone output on the front of the Base Station (6.35 mm jack) to listen to the audio signals of the channels.
Basic information are shown on the display.
Use the jog-dial to navigate through the operating menu.
In the Base Station menu, you can configure a few settings.
You can update the firmware of the Base Station via LinkDesk or Spectera WebUI.
The CHG 70N-C is a network enabled charger featuring two individual charging bays.
These sections contain information about installing, starting up and operating the modular L 6000 charger and the corresponding charging modules.
Note the following information when cleaning and maintaining products of the Spectera series.
Detailed description of the WebUI navigation and configuration.
Detailed description of the installation, start-up and operation of the LinkDesk software.
