Home
User manual
Detailed description of the start-up and operation of your selected hardware and software product.
Spectera
Detailed description of the start-up and operation of your selected hardware.
Base Station
Connecting audio via Dante®
You can input and output audio via Dante®.

User manual
Detailed description of the start-up and operation of your selected hardware and software product.
- Spectera
  Detailed description of the start-up and operation of your selected hardware.
  - Base Station
    - Get started
      Get your Base Station ready to use in a few steps.
    - General information for the System
      Here you can find general information for your use of the System.
    - Product overview
    - Installing slot-in cards
      The same or different cards can be installed.
    - Connecting/disconnecting the Base Station to/from the power supply system
    - Connecting to a network
      Connect the Base Station to a network for monitoring and controlling.
    - Connecting antennas
      You can connect up to four antennas to the Base Station.
    - Connecting word clock
      You can use the internal word clock on the Base Station or connect an external word clock.
    - Connecting audio via Dante®
      You can input and output audio via Dante®.
    - Connecting audio via MADI
    - Changing the fan filter
      The filter protects the fans from dust.
    - Installing the Base Station in a rack
      You can install the Base Station in any conventional 19" rack. The rack mounting angles are already attached to the device.
    - Switching the Base Station on and into standby
    - Activating a license (general)
    - Using the headphone output
      You can use the headphone output on the front of the Base Station (6.35 mm jack) to listen to the audio signals of the channels.
    - Meaning of the LED
    - Information on the display
      Basic information are shown on the display.
    - Navigating the menu
      Use the jog-dial to navigate through the operating menu.
    - Menu structure
      In the Base Station menu, you can configure a few settings.
    - Updating the Base Station
      You can update the firmware of the Base Station via LinkDesk or Spectera WebUI.
  - SEK
  - DAD
  - CHG 70N-C charger
    The CHG 70N-C is a network enabled charger featuring two individual charging bays.
  - L 70 USB charger
  - Modular L 6000 charger
    These sections contain information about installing, starting up and operating the modular L 6000 charger and the corresponding charging modules.
  - Cleaning and maintenance
    Note the following information when cleaning and maintaining products of the Spectera series.
- WebUI
  Detailed description of the WebUI navigation and configuration.
- LinkDesk
  Detailed description of the installation, start-up and operation of the LinkDesk software.

Connecting audio via Dante®

You can input and output audio via Dante®.

To connect audio via Dante®:

Plug one side of a ruggedized RJ45 cable to the Dante® primary socket.
Plug the other side into a router.
Download the Dante® Controller.
This is typically a host computer (PC or Mac), with the Dante® Controller software application installed. This application configures and controls all the Dante® devices and audio streams inside the network.

Information about the Dante Controller and the Dante® network protocol settings is available on the Audinate website: audinate.com.

The Base Station can input and output audio via Dante®.

Shared network mode

In Shared Network Mode both networks for Control and Dante® are using the same physical network infrastructure.

Split Network Mode

In Split Network Mode both networks for Control and Dante® are using different physical network infrastructure.

For more information, please refer to the Network & Security Guide, which can be found in the download section on the Base Station product page sennheiser.com/base-station.