Home
User manual
Detailed description of the start-up and operation of your selected hardware and software product.
LinkDesk
Detailed description of the installation, start-up and operation of the LinkDesk software.
Mobile devices
Configuring MIC/LINE output
You can adjust the PREAMP GAIN and LOW CUT of the MIC/ LINE output.

User manual
Detailed description of the start-up and operation of your selected hardware and software product.
- Spectera
  Detailed description of the start-up and operation of your selected hardware.
- WebUI
  Detailed description of the WebUI navigation and configuration.
- LinkDesk
  Detailed description of the installation, start-up and operation of the LinkDesk software.
  - Get started
  - Basic configuration
    Start your basic configuration with the recommended steps.
  - Productions
    In this chapter you will learn the basic information about productions.
  - Base Station
    The Base Station is the central hardware for managing and monitoring all compatible Spectera products.
  - Mobile devices
    - Pairing/unpairing mobile devices
      In LinkDesk you can pair up to 128 mobile devices to a Base Station within one RF channel.
    - Adding mobile devices
      You can add mobile devices to your connected Base Station.
    - Displaying device information
      You can display detailed information relating to your Spectera device.
    - Changing the device name
      You can change the device name for your mobile device.
    - Configuring IEM/IFB input
      You can adjust the BALANCE and VOLUME of the IEM/IFB input.
    - Configuring MIC/LINE output
      You can adjust the PREAMP GAIN and LOW CUT of the MIC/ LINE output.
    - Removing a mobile device
      You can remove your mobile devices from your current production.
    - Updating the firmware (mobile devices)
      The firmware version of the mobile devices can be downloaded and updated manually.
  - Routing editor
    The editor serves as a basic configurator for mobile devices and also provides an overview of all connected devices with their total capacity utilization within an RF spectrum.
  - Error Handling
    Summary of the typical error messages that can occur and how to resolve them.

Configuring MIC/LINE output

You can adjust the PREAMP GAIN and LOW CUT of the MIC/ LINE output.

WARNING

Danger due to high volume levels

Volume levels that are too high may damage your hearing.

Reduce the volume and the microphone amplification, if applicable, before using the product.

To configure the MIC/LINE output:

Click on your mobile device card.
An additional navigation menu will appear on the right-hand side of the window.
Click on the drop-down menu Output MIC/LINE and adapt the settings for:
- TEST TONE, to simulate and test the performance of your audio devices in different dB levels,
- CABLE EMULDATION, to emulate the capacitance of connected cables and influence the sound of your mic/line input,
- PREAMP GAIN, to adjust the pre amplification OR
- LOW CUT, to minimize wind noise.
Click on EDIT ROUTES to configure the audio link mode.