System -> Network menu item

In this menu item, you can configure the settings for the network connection.

To open the Network menu item:
  1. In the System menu, navigate to the Network menu item.

  2. Rotate the jog dial to navigate through the Network menu and select the desired menu item.

    You can make the following settings here:

    Network Mode

    • Single Cable
    • Split
    • Redundancy


    Control
    • Mode
      • Auto: The network configuration is performed automatically.
      • Manual: The network configuration can be performed manually.
    • mDNS
      • You can enable or disable this option if you want to use mDNS for automatic device detection in the network.
    • IP
      • If the Mode option is set to Auto, the automatically assigned IP address is displayed here.
      • If the Mode option is set to Manual, you can set the IP address here.
    • Netmask
      • If the Mode option is set to Auto, the automatically assigned netmask is displayed here.
      • If the Mode option is set to Manual, you can set the netmask here.
    • Gateway
      • If the Mode option is set to Auto, the automatically assigned gateway is displayed here.
      • If the Mode option is set to Manual, you can set the gateway here.
    Dante - Dante Primary and Dante Secondary
    • Mode
      • Auto: The network configuration is performed automatically.
      • Manual: The network configuration can be performed manually.
    • mDNS
      • You can enable or disable this option if you want to use mDNS for automatic device detection in the network.
    • IP
      • If the Mode option is set to Auto, the automatically assigned IP address is displayed here.
      • If the Mode option is set to Manual, you can set the IP address here.
    • Netmask
      • If the Mode option is set to Auto, the automatically assigned netmask is displayed here.
      • If the Mode option is set to Manual, you can set the netmask here.
    • Gateway
      • If the Mode option is set to Auto, the automatically assigned gateway is displayed here.
      • If the Mode option is set to Manual, you can set the gateway here.
    Spanning Tree (STP)
    • If the option is enabled, misconfigurations between network modes and cabling is avoided.
    • If the option is disabled, broadcast storms may result.
    • By default and after a factory reset, STP is enabled.
    The Spanning Tree is configured with a priority of 57344 and should be considered when setting up a network with managed switch so that an EW-DX EM doesn't get the route bridge.
To save the settings you have made:
  1. Turn the jog dial until Apply appears in the selection frame.

  2. Press the jog dial to save your settings.