Outputting audio signals

Each of the four channels on the EW-DX EM 4 Dante has both a balanced XLR-3M output socket and an unbalanced 6.3 mm (1/4") jack output socket.

The balanced XLR -3M output has one Groundlift switch per channel, which interrupts the ground connection between pin 1 of the XLR connector.

  1. Always use only one of the two output sockets for each channel.
To connect an XLR cable:
  1. Plug the XLR cable into the AF out Balanced socket for the respective channel on the EW-DX EM 4 Dante.

To connect a jack cable:
  1. Plug the jack cable into the AF out Unbalanced socket for the respective channel on the EW-DX EM 4 Dante.

To output an audio signal via Dante:
  1. Connect the receiver as described under Connecting receivers in a network.
To adjust the Groundlift:
  1. Slide the desired switch upwards.
    Groundlift has been switched on for the corresponding AF out Balanced channel.
To switch Groundlift off:
  1. Slide the desired switch downwards.
    Groundlift has been switched off for the corresponding AF out Balanced channel.