Starting up and operating devices of the Digital 6000 line.
These sections contain information about installing, starting up and operating the SK 6212 bodypack transmitter.
Navigating through the menu and making changes.
In this menu item, you can reset the transmitter settings to the factory settings.
These sections contain information about installing, starting up and operating the EM 6000 2-channel receiver.
These sections contain information about installing, starting up and operating the SKM 6000 handheld transmitter.
These sections contain information about installing, starting up and operating the SK 6000 bodypack transmitter.
You can connect instruments or audio sources with a line level to the SK 6212 bodypack transmitter.
You can view the following information on the transmitter display.
In this menu item, you can adjust a frequency in 25 kHz steps.
In this menu item, you can set a freely selectable name for the transmitter.
In this menu item, you can adjust the input gain in 3 dB steps.
In this menu item, you can adjust the value for the low cut filter.
In this menu item, you can activate or deactivate the lock-off for the transmitter.
In this menu item, you can activate a 1 kHz test tone that the transmitter transmits instead of the input signal.
In this menu item, you can set the behavior of the LED above the SK 6212’s display and the ON/OFF button.
In this menu item, you can set the transmission power of LR mode in two steps:
In this menu item, you can display the installed firmware version and the overall frequency range for the transmitter.
These sections contain information about installing, starting up and operating the modular L 6000 charger and the corresponding charging modules.
Note the following points when you establish a radio link between the transmitter and receiver.
Note the following information when cleaning and maintaining Digital 6000 series products.
