Displays on the receiver’s display panel

Status information such as frequency, reception quality, battery status and audio level is shown on the display.

The display also shows the operating menu, which you can use to configure all of the settings (see Buttons for navigating the menu).

Home screen

The home screen is the default view on the display. The following information for both receiving channels is displayed here.



Antenna switching diversity:

Indicates which of the two antennas is currently active (left or right).

Signal level:

Displays the RF signal strength for the respective channel.

Link quality:

Displays the transmission quality for the respective channel.

On the one hand, the transmission quality depends on the field strength (RF level indicator on the display). However, on the other hand, it also depends on external sources of interference that cannot be identified on the RF level indicator (for example, they may be on the same frequency or a very close neighboring frequency or may not affect the field strength).

As a basic principle, a value significantly higher than 50% should be achieved for a secure transmission.

Link name:

You can assign a name to the radio link in the receiver menu (see Ch 1 / Ch 2 -> Name menu item).

Frequency:

You can set the frequency of the radio link manually or using the Auto-Setup function.

Transmitter audio level:

Displays the audio input level for the respective channel (see Ch 1 / Ch 2 -> Gain menu item).

This level is separate from the audio level that is output from the receiver (see Ch 1 / Ch 2 -> AF Out menu item).

Transmitter battery:

Indicates the charging status of the transmitter’s BA 70 rechargeable battery or batteries.

When using the BA 70 rechargeable battery, the remaining runtime is also displayed in hours and minutes.

Mute mode:
The mute switch is deactivated on the received transmitter.
The mute switch on the received transmitter is set to AF Mute and the audio signal is muted.
Headphones:
The headphones icon indicates which channel is currently active on the headphone output (see Using the headphone output).
Sync state:
This icon indicates that different values are set for the receiving channel of the receiver and the transmitter. These values can be synchronized (see Connecting to the EW-DX EM receivers / synchronizing the EW-DX EM).
System icons:
The LD icon is displayed when Link Density mode is activated. See System -> Link Density menu item.
The lock icon is displayed when the Auto Lock function is enabled. See Lock-off function.
The network icon appears when a network connection is successfully established. See Connecting receivers in a network.
The shield icon is displayed when AES 256 encryption is enabled. See System -> Encryption menu item.