Home
Instruction manual
Starting up and operating devices of the Evolution Wireless Digital series.
EW-DX EM 2 rack receiver
Outputting audio signals

Instruction manual
Starting up and operating devices of the Evolution Wireless Digital series.
- EW-D EM rack receiver
- EW-D SKM-S handheld transmitter
- EW-D SK bodypack transmitter
- EW-DX EM 2 rack receiver
  - Product overview
  - Connecting/disconnecting the receiver to/from the power supply system
  - Connecting receivers in a network
  - Connecting antennas
  - Outputting audio signals
  - Installing receivers in a rack
    Observe the following instructions when mounting the receiver in a rack.
  - Switching the receiver on and off
  - Lock-off function
  - Using the headphone output
    You can use the headphone output on the front of the receiver (6.3 mm jack) to listen to the audio signals of the two channels.
  - Meaning of the LEDs
  - Displays on the receiver’s display panel
    Status information such as frequency, reception quality, battery status and audio level is shown on the display.
  - Buttons for navigating the menu
  - Opening the menu and navigating the menu items
  - Menu structure
    The figure shows the complete menu structure in an overview.
  - Setting options in the menu
    In the receiver menu, you can configure the following settings.
  - System menu item
  - Updating the firmware of the receiver
    You can update the receiver firmware using the Sennheiser Control Cockpit software, the Wireless Systems Manager software or the Smart Assist app.
- EW-DX EM 2 Dante rack receiver
- EW-DX EM 4 Dante rack receiver
- EW-DX SKM | EW-DX SKM-S handheld transmitter
- EW-DX SK | EW-DX SK 3-PIN bodypack transmitter
- Table stand EW-DX TS 3-pin | EW-DX TS 5-pin
- EW-DP EK portable receiver
- EW-DP SKP plug-on transmitter
- Establishing a radio link | Synchronizing the receiver and transmitter
- L 70 USB charger
- CHG 70N-C charger
  The CHG 70N-C is a network enabled charger featuring two individual charging bays.
- EW-D ASA antenna splitter
- AWM active directional antenna
- Cleaning and maintenance
  Note the following information when cleaning and maintaining products of the Evolution Wireless Digital series.

Outputting audio signals

Each of the two channels on the EW-DX EM 2 has both a balanced XLR-3M output socket and an unbalanced 6.3 mm (1/4") jack output socket.

Always use only one of the two output sockets for each channel.

To connect an XLR cable:

Plug the XLR cable into the AF out Balanced socket for the respective channel on the EW-DX EM 2.

To connect a jack cable:

Plug the jack cable into the AF out Unbalanced socket for the respective channel on the EW-DX EM 2.