Installing receivers in a rack
Observe the following instructions when mounting the receiver in a rack.
The mounting brackets for installing the receiver in the rack can be found in the packaging under the tray:
| NOTICE | |
|---|---|
Rack mounting poses risks!
When installing the device in a closed 19" rack or multi-rack assembly, please consider that, during operation, the ambient temperature, the mechanical load and the electrical potentials will be different from those of devices which are not mounted into a rack.
Make sure that the ambient temperature within the rack does not exceed the permissible temperature limit stated in the specifications. See Specifications.
Ensure sufficient ventilation; if necessary, provide additional ventilation.
Make sure that the mechanical load of the rack is even.
When connecting to the power supply system, observe the information indicated on the type plate. Avoid overloading the circuits. If necessary, provide overcurrent protection.
When mounting in a rack, please note that intrinsically harmless leakage currents of the individual power supply units may accumulate, thereby exceeding the permissible limit value. As a remedy, ground the rack via an additional ground connection.
| |
Mounting a single receiver in a rack
-
Connect the mounting brackets to the sides of the receiver as shown.
- Attach the front panel as shown.
-
If desired, attach the antennas to the front panel as shown. This requires the optional AM 2 antenna front mount kit (see Accessories for rack mounting).
Mounting two receivers side by side in a rack
- Place both receivers upside down and side by side on an even surface.
- Tighten the jointing plate as shown.
-
Attach the mounting brackets as shown.
