Instruction manual
Starting up and operating devices of the XS Wireless series.
- EM-XSW 1 rack receiver
- EM-XSW 1 DUAL rack receiver
- EM-XSW 2 rack receiver
  - Product overview
  - Connecting/disconnecting the receiver to/from the power supply system
  - Connecting antennas
  - Outputting audio signals
  - Installing receivers in a rack
  - Switching the receiver on and off
  - Information on the receiver’s display
    Status information such as frequency, reception quality, battery status and audio level is shown on the display.
  - Setting options on the front of the device
    - SCAN menu item
      Under the SCAN menu item, you can perform an automatic frequency scan of your area.
    - PRESET menu item
      Under the PRESET menu item, you can set the radio frequency by selecting a preset channel.
    - TUNE menu item
      Under the TUNE menu item, you can manually set the radio frequency independently of the preset channels.
    - Adjusting the volume of the audio outputs
  - Setting options on the rear of the device
  - Configuring a multi-channel system
- SKM XSW handheld transmitters
- SK-XSW bodypack transmitter
- Establishing a radio link | Synchronizing the receiver and transmitter
- Cleaning and maintenance
  Note the following information when cleaning and maintaining products of the Evolution Wireless Digital series.

Adjusting the volume of the audio outputs

Use the VOLUME control knob to set the level of the audio signal coming from the receiver’s audio outputs (Balanced/Unbalanced). This audio signal can be output to a mixing console or an amplifier, for example.

Turn the VOLUME control knob to adjust the volume.
Make sure that the signal in the next device in the signal chain (e.g. mixing console, power amplifier, guitar amplifier, etc.) is not overdriven.