Performing a walk test with the SL Rack Receiver DW in the Control Cockpit

To perform a walk test in the Control Cockpit:
  1. Switch on the transmitter and the receiver of the radio link you want to check.
  2. In addition, switch on all other devices that you want to use in the operating environment.
  3. Select the device in the Control Cockpit.
  4. Open the RF settings tab.

  5. Click Start under Walk Test.

  6. Walk the operating environment with the transmitter.
    The display of the radio signal level is continuously updated.
  7. Click Stop to end the walk test.

If the result of the walk test is not satisfying, you can take the following remedial measures:

  • If possible, position the receiver so that there is always a direct line of sight between the antennas (directly on the receiver or remotely mounted) and the paired transmitter.
  • If possible, remove obstacles between the transmitter and the antennas.
  • Pay attention to the notes about antenna installation: Recommendations on antenna mounting.
  • If necessary, adjust the manually selected transmission power in the Control Cockpit under RF power mode on the RF settings tab. You can find more information under Multi-room mode.