Version 1.2.0

New features

  • Optimization of audio level visualization on SEK card
  • SEK Card States - Battery Low and Signal Loss
  • IEM Headphone Detection
  • Enabling the usage of Enter keystroke in Input fields & first steps on keyboard navigation
  • Manually select DADs to remove them from an RF Channel

Improvements

  • Higher security level for RF mute and unmute setting
  • Inform, Opt-In, Opt-Out for production data tracking

Bug fix

  • Several bug fixes and optimizations

Known issues

Installation
  • Information for beta testers:

    If you had a previous version of LinkDesk installed: due to improvements in the database migration, your existing databases will not be automatically imported.

Log-In

  • If you log in into your Sennheiser Account during app startup, the startup animation might be displayed a second time afterwards.

Reset Base Station when adding to production
  • If there are 50+ mobile devices and numerous audio links set up, it may take a few attempts to successfully reset the Base Station when adding it to a production.
Device synchronization
  • If the mobile devices in a production are no longer paired with the Base Station, they will be removed from the production. You will need to re-pair and re-configure them.
  • If the network settings (IP address) of a Base Station in a production are changed, it cannot be synced again and will remain disconnected as long as the IP address differs from that stored in the production.

    Workaround: update the IP address on the Base Station to match the one stored in LinkDesk, then sync again.

  • Existing devices (Base Station and mobile devices) in a production cannot be swapped with other or new devices at this time.

  • In rare cases, antennas may not be detected after triggering the device synchronization process. Re-triggering the process can resolve the issue.

Pairing

  • In rare instances, pairing may result in duplicate mobile device cards appearing.

    Workaround: to resolve this, toggle the device sync button off and then on again.

Antenna validation
  • Currently, no error is displayed if an incompatible antenna type (UHF or 1G4) is connected to an antenna port that is already assigned to an existing RF channel (UHF or 1G4).
FW update
  • In some cases, not all mobile devices may be visible during a firmware update.
  • Please avoid locking your PC during the firmware update, as it may cause the process to stop.
Dante® audio interface status
  • When the Dante® Primary Control cable is disconnected from the Base Station, the system may incorrectly display a ‘Connected’ status.

    Workaround: if you experience issues with Dante®, please use the Spectera WebUI to check the system status and settings.

MD setup

  • During the configuration of the Audio Link Mode, a temporary Signal Loss Warning may be displayed on the SEK card. This is caused by the data refresh timing.
    Please note that ungrouping an audio group in the routing editor will result in all associated SEKs losing their routing assignments and link mode.