Home
User manual
Detailed description of the start-up and operation of your selected hardware and software product.
WebUI
Detailed description of the WebUI navigation and configuration.
Configuration
Under Configuration, you can set the essential settings for the RF channel, antenna, Base Station and mobile devices.
RF Configuration
Here you can set up your RF channel and check the status of local permissions, your connected antenna, and any potential frequency interference in the surrounding area.
Configuring RF channels
Here you can find out how to configure the RF channel right from the start.

User manual
Detailed description of the start-up and operation of your selected hardware and software product.
- Network & Security Guide
  This document is intended for IT administrators, system integrators and event technicians and serves as an planning and configuration guide for integrating components of the Spectera offering into diverse network environments from small home networks up to enterprise networks.
- Spectera
  Detailed description of the start-up and operation of your selected hardware.
- WebUI
  Detailed description of the WebUI navigation and configuration.
  - Get started
    Starting the WebUI for the first time, including device authentication and license entitlement.
  - Resetting device password
    You can reset the assigned device password on your Base Station to its factory settings.
  - Basic configuration
    Start your basic configuration with the recommended steps.
  - Configuration
    Under Configuration, you can set the essential settings for the RF channel, antenna, Base Station and mobile devices.
    - RF Configuration
      Here you can set up your RF channel and check the status of local permissions, your connected antenna, and any potential frequency interference in the surrounding area.
      - Scanning RF frequency
        You can run a frequency scan to check the current frequency situation in your surrounding area.
      - Configuring RF channels
        Here you can find out how to configure the RF channel right from the start.
      - Assigning an antenna for RF channel
        You can choose between up to four connected antennas to assign them to your two possible RF channels.
    - Base Station
      Here, you can check the basic settings of the Base Station and easily perform tasks like firmware updates, walk tests, or restoring it to factory settings.
    - Audio Interfaces
      Here you can monitor all available interfaces and manage the outputs.
    - Mobile Devices
      Here you can configure specific settings for mobile devices.
    - Activating license
      Under Entitlement, you can enter and activate the current license for the frequency spectrum.
  - Frequency Scan
    You can use an RF scan to examine the current frequency situation of your connected antenna.
  - Audio Levels
    Under Audio Levels you can monitor all interfaces at a glance.
  - Audio inputs and outputs
    Here you have an overview of all channels at a glance and can assign the audio network input and output for the link channels directly and easily.
- LinkDesk
  Detailed description of the installation, start-up and operation of the LinkDesk software.

Configuring RF channels

Here you can find out how to configure the RF channel right from the start.

The current local permissions are displayed when the frequency is selected.

To configure an RF channel:

In the top bar, navigate to Configuration > RF Configuration.
For channel RF1, enter the frequency under 1 and confirm with ENTER.
Next, select the Bandwidth and the RF Power for your location.
The applicability of your settings is indicated by an icon:
- green: applicable
- red: not applicable
Under RF Startup, select the mute option for the configured RF channel:
- Active
- Muted
- Last state = When switching on or leaving standby mode, the last used RF state is restored
The RF Channel has been assigned to the operating antenna.

The RF Channel has been configured.