Home
User manual
Detailed description of the start-up and operation of your selected hardware and software product.
WebUI
Detailed description of the WebUI navigation and configuration.
Get started
Starting the WebUI for the first time, including device authentication and license entitlement.

User manual
Detailed description of the start-up and operation of your selected hardware and software product.
- Spectera
  Detailed description of the start-up and operation of your selected hardware.
- WebUI
  Detailed description of the WebUI navigation and configuration.
  - Get started
    Starting the WebUI for the first time, including device authentication and license entitlement.
    - Identifying Base Station via IP
      In order to add a Base Station, its IP address is required.
    - Claiming single device (WebUI)
      Instructions for claiming a single device in Spectera WebUI.
    - Activating a license (webUI)
      Under Entitlement, you can enter and activate the current license for the frequency spectrum.
  - Resetting the device password
    You can reset the assigned device password on your Base Station to its factory settings.
  - Basic configuration
    Start your basic configuration with the recommended steps.
  - Configuration
    Under Configuration, you can set the essential settings for the RF channel, antenna, Base Station and mobile devices.
  - Frequency Scan
    You can use an RF scan to examine the current frequency situation of your connected antenna.
  - Audio levels
    Under Audio Levels you can monitor all interfaces at a glance.
  - Audio inputs and outputs
    Here you have an overview of all channels at a glance and can assign the audio network input and output for the link channels directly and easily.
- LinkDesk
  Detailed description of the installation, start-up and operation of the LinkDesk software.

Get started

Starting the WebUI for the first time, including device authentication and license entitlement.

When adding the Base Station for the first time, three intermediate steps are required:

Identifying the Base Station via IP (see Network).
Authenticating the Base Station using the configured password (see Claiming single device (WebUI)).
Activating the Base Station license (see Activating a license (webUI)).

If the Base Station IP is used via LinkDesk at the same time, the control buttons in the WebUI are deactivated. In this case, the user can monitor, but can no longer intervene actively.

Operational data is collected to continuously improve the stability and functionality of Spectera. The data is pseudonymized to ensure there is no direct personal reference. Tracking can be disabled in the settings (see chapter Enabling/disabling data collection).