Replacing the belt clip

To replace the belt clip, you will need the following materials:

To remove the belt clip:

Place the receiver on a soft cloth with the front of the housing facing down.
Insert a slotted screwdriver with a maximum width of 1.0 mm into the gap between the first plastic fastener and the housing.

Carefully lever out the plastic fastener.

Work the hook on the bottom of the plastic fastener free so that you can remove the plastic fastener with tweezers.

If you cannot remove the plastic fastener easily, try also levering out the second hook on the faster toward the inside.

CAUTION

Risk of injury if the clip pops out.

The clip is under mechanical tension and can cause injuries if it springs out uncontrollably.

During disassembly, keep one side of the clip firmly pressed against the housing.

Repeat this procedure for the second plastic fastener.
During disassembly, press one side of the clip firmly against the housing while pulling the other end of the clip out toward the center of the housing and over the plastic protrusion.
Pull the second end of the clip out of the housing and remove the clip.
Discard the old plastic fasteners and clip.

To install the belt clip:

CAUTION

Risk of injury if the clip pops out.

The clip is under mechanical tension and can cause injuries if it springs out uncontrollably.

During disassembly, keep one side of the clip firmly pressed against the housing.

Take the new belt clip and insert the left end of the clip into the left hole in the housing to the left of the plastic protrusion.
Press the left end of the clip against the housing while using your other hand to insert the other end of the clip into the right opening in the housing to the right of the plastic protrusion.
Use tweezers to insert the new plastic fasteners into the holes in the housing with the hooks pointing downward.
Press the plastic fasteners in with your finger.
The plastic fasteners will snap into place.