Synchronizing devices

You can synchronize the XSW IEM transmitter and receiver using the infrared interfaces. The channel selected on the transmitter is transmitted to the receiver.

To synchronize the devices, ensure that no menu is selected on the transmitter (no values flashing). Before using the device, check whether there are interfering frequencies in your frequency range (Finding an interference-free frequency (frequency test)).
To synchronize the devices:
  1. Switch the transmitter and the receiver on.
  2. Press the SYNC button on the transmitter.
    The SYNC display flashes on the transmitter display panel for 10 seconds.
  3. Hold the infrared interface of the receiver in front of the infrared interface of the transmitter.
    The parameters are transferred to the receiver.

    Once transmission is complete, the transmitter returns to the default display.



To cancel synchronization:
  1. Press either the SET button, the UP button or the DOWN button on the transmitter.
    The transmitter reverts to the default display.