Activating power saving mode

In power saving mode, the transmitters are charged only once. The charger also does not provide any trickle charge.

To activate power saving mode:
  1. Hold the network reset button for 10 seconds.

    All LEDs will light up once and power saving mode will be activated.

    All LEDs remain off while power saving mode is activated. They do not light up even during the one-time charging process.

To deactivate power saving mode:
  1. Disconnect the charger from the power supply system.
  2. Then reconnect it to the power supply system.
    The charger will start up in the configuration that was set before you activated power saving mode.