This menu item lets you perform a firmware update for the transmitters. This update is recommended after you perform a firmware update for the receiver (see Updating the firmware of the receiver).
The firmware versions currently installed on the connected transmitter can be viewed under the TX Software menu item for the respective channel (see Ch 1 / Ch 2 -> TX Software menu item).
To open the TX Update menu item:
In the System menu, navigate to the TX Update menu item.
Press the jog dial to open the menu.
The available sender firmware is displayed:
Press the jog dial to start the firmware update.
Press the SYNC button on the connected transmitter for 3 seconds.
You have about 20 seconds to do this. The progress bar shows the remaining time.
The system carries out the firmware update for the transmitter.
The progress of the update is shown on the receiver’s display.
The transmitter’s display shows that the firmware update is in progress.
NOTICE
Canceling the update can impair the function of the transmitter
If the transmitter is turned off during the firmware update, the update may fail and the transmitter may cease to function correctly.
Do not turn off the transmitter during the update.
Do not remove the batteries or rechargeable battery pack during the update.
Make sure that the transmitter’s (rechargeable) batteries are sufficiently charged before updating.