Instruction manual
Starting up and operating devices of the Evolution Wireless Digital series.
- EW-D EM rack receiver
- EW-D SKM-S handheld transmitter
- EW-D SK bodypack transmitter
- EW-DX EM 2 rack receiver
- EW-DX EM 2 Dante rack receiver
- EW-DX EM 4 Dante rack receiver
  - Product overview
  - Connecting/disconnecting the receiver to/from the power supply system
  - Connecting receivers in a network
  - Connecting receivers in a Dante® network
    - Information
    - Connections and network settings
  - Connecting antennas
  - Outputting audio signals
  - Activating third-party access
    The new SSCv2 protocol enables the configuration and monitoring of devices via encrypted REST API calls and requires a device password by default.
  - Installing receivers in a rack
    You can install the receiver in any conventional 19" rack. The rack mounting angles are already attached to the device.
  - Switching the receiver on and off
  - Lock-off function
  - Using the headphone output
    You can use the headphone output on the front of the receiver (6.3 mm jack) to listen to the audio signals of the four channels.
  - Meaning of the LEDs
  - Displays on the receiver’s display panel
    Status information such as frequency, reception quality, battery status and audio level is shown on the display.
  - Buttons for navigating the menu
  - Opening the menu and navigating the menu items
  - Menu structure
    The figure shows the complete menu structure in an overview.
  - Setting options in the menu
    In the receiver menu, you can configure the following settings.
  - System menu item
  - Updating the firmware of the receiver
    You can update the receiver firmware using the Sennheiser Control Cockpit software, the Wireless Systems Manager software or the Smart Assist app.
- EW-DX SKM | EW-DX SKM-S handheld transmitter
- EW-DX SK | EW-DX SK 3-PIN bodypack transmitter
- Table stand EW-DX TS 3-pin | EW-DX TS 5-pin
- EW-DP EK portable receiver
- EW-DP SKP plug-on transmitter
- Establishing a radio link | Synchronizing the receiver and transmitter
- L 70 USB charger
- CHG 70N-C charger
  The CHG 70N-C is a network enabled charger featuring two individual charging bays.
- EW-D ASA antenna splitter
- AWM active directional antenna
- Cleaning and maintenance
  Note the following information when cleaning and maintaining products of the Evolution Wireless Digital series.

Connections and network settings

Single cable mode

Factory setting


	Network control / Dante primary
	Dante primary

The cable can be connected to network connections I, II or III.

Daisy-chain


	Network control / Dante
	Dante

Split mode

Split 1 without daisy-chain


	Network control
	Dante primary

Split 1 with daisy-chain


	Network control
	Dante primary

Redundancy mode


	Network control
	Dante primary
	Dante secondary