Home
User manual
Starting up and operating devices of the XS Wireless series.
EM-XSW 2 rack receiver
Setting options on the front of the device
SCAN menu item
Under the SCAN menu item, you can perform an automatic frequency scan of your area.

User manual
Starting up and operating devices of the XS Wireless series.
- EM-XSW 1 rack receiver
- EM-XSW 1 DUAL rack receiver
- EM-XSW 2 rack receiver
  - Product overview
  - Connecting/disconnecting the receiver to/from the power supply system
  - Connecting antennas
  - Outputting audio signals
  - Installing receivers in a rack
  - Switching the receiver on and off
  - Information on the receiver’s display
    Status information such as frequency, reception quality, battery status and audio level is shown on the display.
  - Setting options on the front of the device
    - SCAN menu item
      Under the SCAN menu item, you can perform an automatic frequency scan of your area.
    - PRESET menu item
      Under the PRESET menu item, you can set the radio frequency by selecting a preset channel.
    - TUNE menu item
      Under the TUNE menu item, you can manually set the radio frequency independently of the preset channels.
    - Adjusting the volume of the audio outputs
  - Setting options on the rear of the device
  - Configuring a multi-channel system
- SKM XSW handheld transmitters
- SK-XSW bodypack transmitter
- Establishing a radio link | Synchronizing the receiver and transmitter
- Cleaning and maintenance
  Note the following information when cleaning and maintaining products of the Evolution Wireless Digital series.

SCAN menu item

Under the SCAN menu item, you can perform an automatic frequency scan of your area.

This enables you to easily find and assign free radio frequencies.

Switch off all transmitters before you perform the scan. If transmitters are still switched on, they are detected as unavailable frequencies and the frequencies that are actually available cannot then be used.

Press the UP or DOWN button until the SCAN menu item appears in the display.
Press the SET button to open the menu item.
Press the UP or DOWN button to select a frequency bank.
Press the SET button to start the frequency scan in the selected bank.
The next free frequency is shown on the display.
Press the SET button to accept the displayed frequency.
OR
Press the UP or DOWN button to display the next free frequency.
OR
Press the ON/OFF (ESC) button to cancel the scan.
The previous frequency remains unchanged.

If you have set a new frequency, you must still synchronize the receiver with the transmitter to establish the radio link (see Establishing a radio link | Synchronizing the receiver and transmitter).