Variant 1: installed flush in a dropped/coffered ceiling

The TeamConnect Ceiling 2 can be easily installed in a dropped ceiling or coffered ceiling with square ceiling tiles (600 x 600 mm). Angle brackets are available for ceiling tiles with the standard dimensions of 2 ft or 625 mm.

When flush mounting, do not install the TeamConnect Ceiling 2 directly next to lights or other electrical devices in the ceiling.

A: secured with SL CM SK suspension kit
TeamConnect Ceiling 2 Absicherung Überblick

B: secured with eye bolts
TeamConnect Ceiling 2 Sicherung Überblick


TeamConnect Ceiling 2 Sicherung Überblick

  1. Hand-tighten the M4x10 eye bolts in the TeamConnect Ceiling 2 to avoid damaging the metal housing by screwing them in too deeply.
  2. Make sure that the thread on the eye bolt is fully within the thread at the mounting point.
    Recommended cabling

    Observe the following when connecting and running the cables:

    • Always run the cables carefully and in a loop shape inside the installation recess.
    • Make sure not to kink the cables to avoid breaking them or damaging the plugs.

    TeamConnect Ceiling 2 Kabel richtig verlegen Empfehlung

    Recommended paint protection measures

    Protect the surface of your TeamConnect Ceiling 2 against scratches or damage to the paint by using the clear rubber feet included with delivery.

    • On the underside of the TeamConnect Ceiling 2, clean the areas where you want to attach the feet.
    • Attach the feet to the product.

    TeamConnect Ceiling 2 Lack schützen


    TeamConnect Ceiling 2 Gummifüße anbringen

Installing the TeamConnect Ceiling 2 without mounting bracket in the ceiling (600x600 mm grid):
  1. Remove a tile from the ceiling.
  2. Place the TeamConnect Ceiling 2 in the frame in the coffered ceiling.
  3. Maintain the distances indicated in the figure.
    TeamConnect Ceiling 2 Abstandsübersicht
Installing the TeamConnect Ceiling 2 with mounting brackets in the ceiling (2x2 ft or 625x625 mm grid):
  1. Attach the mounting brackets to the TeamConnect Ceiling 2 as shown in the figure.
    TeamConnect Ceiling 2 Abstandsübersicht
  2. Remove a tile from the ceiling.
  3. Place the TeamConnect Ceiling 2 in the frame in the coffered ceiling.
  4. Maintain the distances indicated in the figures.
  5. Mounting with SL CM EB US:
    TeamConnect Ceiling 2 Abstandsübersicht SL CM EB US

  6. Mounting with SL CM EB 625:
    TeamConnect Ceiling 2 Abstandsübersicht SL CM EB 625
The Team Connect Ceiling 2 is now mounted flush with the ceiling.