Home
User manual
Detailed description of mounting, commissioning, operation, maintenance, and transport of the product.
Initial configuration in the Control Cockpit
This section guides you step by step through the initial configuration using tried-and-trusted methods and procedures.
Claiming the TC Bar for a specific Control Cockpit instance (network solution)
The TC Bar is delivered with password protection for the configuration. This device must be claimed by a Control Cockpit instance before you can view and modify its configuration.
Manually adding the TC Bar to the Control Cockpit
If the Control Cockpit does not automatically detect the TC Bar, you can add it manually using an IP.

User manual
Detailed description of mounting, commissioning, operation, maintenance, and transport of the product.
- Product overview
- Mounting
- Putting the unit into operation
  This chapter describes the initial configuration and commissioning of the TC Bar.
- Initial configuration in the Control Cockpit
  This section guides you step by step through the initial configuration using tried-and-trusted methods and procedures.
  - Claiming the TC Bar for a specific Control Cockpit instance (network solution)
    The TC Bar is delivered with password protection for the configuration. This device must be claimed by a Control Cockpit instance before you can view and modify its configuration.
    - Manually adding the TC Bar to the Control Cockpit
      If the Control Cockpit does not automatically detect the TC Bar, you can add it manually using an IP.
  - Selecting a sound profile
    Sound profiles are presets that are optimized for the intended mounting options.
  - Stipulating a device profile for the camera
    Device profiles contain custom or predefined settings for supported conference and collaboration platforms.
  - Selecting a network mode
    You can configure the various network modes using the panel in Sennheiser’s control software.
- Operating instructions
  The following chapters contain additional information on operating the TC Bar.
- Cleaning and maintenance
  Note the following information when cleaning and maintaining the product.
- Replacing remote control batteries
  You can replace the AAA 1.5 V batteries on your own .
- Storing accessories
  You can store both the remote control and the lens cap in the bracket.
- Transport
  Here you will find information about properly preparing the TC Bar for transport.

Manually adding the TC Bar to the Control Cockpit

If the Control Cockpit does not automatically detect the TC Bar, you can add it manually using an IP.

To add the TC Bar to the list of devices in the Sennheiser Control Cockpit:

On the Devices tab in the Control Cockpit, click Add device.
A dialog window with additional input fields appears.
Enter the IP address of the TC Bar. Alternatively, you can also enter an address range to add several devices at the same time.
Then click Save.

The TC Bar was successfully added. If the TC Bar is still not visible, refresh the web interface of the Control Cockpit using the switch Refresh list.