Home
Instruction manual
Detailed description of the start-up and operation of your selected hardware.
SEK
Pairing the SEK to the Base Station

Instruction manual
Detailed description of the start-up and operation of your selected hardware.
- Base Station
- SEK
  - Product overview
  - Inserting and removing the rechargeable battery
    The SEK operates only with the recharable battery BA 70 (seperate accessory).
  - Mounting the antenna
    Two antennas are available, one for each frequency range.
  - Using the protection cap
    The cap protects the microphone / instrument input, when not in use.
  - Connecting a microphone / instrument
    You can connect a microphone or instrument to the SEK.
  - To use the Phones jack
  - Changing the belt clip
    You can change the belt clip on the SEK or flip it over depending on how you want to wear it.
  - Meaning of the LEDs
    The Status LED and LEDs can indicate the following information.
  - Switching the SEK on and off
  - Information on the display
    You can view the following information on the SEKs display.
  - Pairing the SEK to the Base Station
  - Updating the SEK
    You can update the firmware of the SEK via Spectera WebUI.
- DAD
- CHG 70N-C charger
  The CHG 70N-C is a network enabled charger featuring two individual charging bays.
- L 70 USB charger
- Modular L 6000 charger
  These sections contain information about installing, starting up and operating the modular L 6000 charger and the corresponding charging modules.
- Cleaning and maintenance
  Note the following information when cleaning and maintaining products of the Spectera series.

Pairing the SEK to the Base Station

Mobile devices can only be paired and operated with one Base Station at a time.

You can pair up to 128 mobile devices to a Base Station within one RF channel.

Please make sure that on the Base Station

a RF channel is configured and
this RF channel is activated (RF on).

To pair the SEK to a Base Station:

Put the Base Station into Pairing Mode using Spectera WebUI.
The LED flashes blue.

Pairing Mode is activated for five minutes. The audio signal is not interrupted.
While the SEK is off, long-press the ON/OFF button until the Status LED is blue.
The status LED is flashing blue while searching for a new Base Station.
When the SEK found the Base Station, the status LED is flashing blue quickly and then is blue.

The SEK appears in the software.
Confirm the pairing in the software, see Spectera WebUI: Pairing/unpairing mobile devices.
The status LED of the SEK is flashing green quickly while connecting. When connecting is completed, the status LED is green.

To unpair the SEK from a Base Station:

The SEK can only be unpaired in Spectera WebUI.
- Spectera WebUI: Pairing/unpairing mobile devices
The SEK will automatically switch to pairing mode. The status LED is flashing blue.

The SEK has been paired to a Base Station.