Home
User manual
Detailed description of the start-up and operation of your selected hardware and software product.
Spectera
Detailed description of the start-up and operation of your selected hardware.
Modular L 6000 charger
These sections contain information about installing, starting up and operating the modular L 6000 charger and the corresponding charging modules.
Installing the L 6000 in a rack
You can install the L 6000 charger in any conventional 19" rack.

User manual
Detailed description of the start-up and operation of your selected hardware and software product.
- Network & Security Guide
  This document is intended for IT administrators, system integrators and event technicians and serves as an planning and configuration guide for integrating components of the Spectera offering into diverse network environments from small home networks up to enterprise networks.
- Spectera
  Detailed description of the start-up and operation of your selected hardware.
  - Network & Security Guide
    This document is intended for IT administrators, system integrators and event technicians and serves as an planning and configuration guide for integrating components of the Spectera offering into diverse network environments from small home networks up to enterprise networks.
  - Base Station
  - SEK
  - DAD
  - CHG 70N-C charger
    The CHG 70N-C is a network enabled charger featuring two individual charging bays.
  - L 70 USB charger
  - Modular L 6000 charger
    These sections contain information about installing, starting up and operating the modular L 6000 charger and the corresponding charging modules.
    - Product overview
    - Connecting/disconnecting the L 6000 to/from the power supply system
    - Connecting the L 6000 to a network
    - Installing a charging module in the L 6000 charger
      The following charging modules are available for the L 6000 charger.
    - Installing the L 6000 in a rack
      You can install the L 6000 charger in any conventional 19" rack.
    - Switching the L 6000 on and off
      The L 6000 does not have a separate on/off switch.
    - Charging the rechargeable batteries in the L 6000 charger
    - Meaning of the LEDs
    - Preparing rechargeable batteries for storage (storage mode)
    - Resetting settings (factory reset)
    - Updating the firmware
    - Operating the L 6000 via a network
  - Cleaning and maintenance
    Note the following information when cleaning and maintaining products of the Spectera series.
- WebUI
  Detailed description of the WebUI navigation and configuration.
- LinkDesk
  Detailed description of the installation, start-up and operation of the LinkDesk software.

Installing the L 6000 in a rack

You can install the L 6000 charger in any conventional 19" rack.

The rack mounting angles are already attached to the device.

Always observe the following information during rack mounting.

NOTICE

Material damages caused by devices overheating

When there is insufficient ventilation, the devices mounted in the rack may overheat.

Ensure that there is sufficient ventilation in the rack, particularly if several devices are installed.

If necessary, install a fan in the rack.

Support the EM 6000 after installation in the rack. Due to the weight and depth of the device, there is a risk that it may break off in the rack and become damaged as a result.

Version A:

Use special rack mounting rails.
The design of the rack used must be suitable for the installation of these mounting rails.

Version B:

Use a suitable object to support the device on the rear side.
Ensure that this object cannot become loose.