Home
User manual
Detailed description of the start-up and operation of your selected hardware and software product.
Spectera
Detailed description of the start-up and operation of your selected hardware.
Modular L 6000 charger
These sections contain information about installing, starting up and operating the modular L 6000 charger and the corresponding charging modules.
Connecting the L 6000 to a network

User manual
Detailed description of the start-up and operation of your selected hardware and software product.
- Network & Security Guide
  This document is intended for IT administrators, system integrators and event technicians and serves as an planning and configuration guide for integrating components of the Spectera offering into diverse network environments from small home networks up to enterprise networks.
- Spectera
  Detailed description of the start-up and operation of your selected hardware.
  - Network & Security Guide
    This document is intended for IT administrators, system integrators and event technicians and serves as an planning and configuration guide for integrating components of the Spectera offering into diverse network environments from small home networks up to enterprise networks.
  - Base Station
  - SEK
  - DAD
  - CHG 70N-C charger
    The CHG 70N-C is a network enabled charger featuring two individual charging bays.
  - L 70 USB charger
  - Modular L 6000 charger
    These sections contain information about installing, starting up and operating the modular L 6000 charger and the corresponding charging modules.
    - Product overview
    - Connecting/disconnecting the L 6000 to/from the power supply system
    - Connecting the L 6000 to a network
    - Installing a charging module in the L 6000 charger
      The following charging modules are available for the L 6000 charger.
    - Installing the L 6000 in a rack
      You can install the L 6000 charger in any conventional 19" rack.
    - Switching the L 6000 on and off
      The L 6000 does not have a separate on/off switch.
    - Charging the rechargeable batteries in the L 6000 charger
    - Meaning of the LEDs
    - Preparing rechargeable batteries for storage (storage mode)
    - Resetting settings (factory reset)
    - Updating the firmware
    - Operating the L 6000 via a network
  - Cleaning and maintenance
    Note the following information when cleaning and maintaining products of the Spectera series.
- WebUI
  Detailed description of the WebUI navigation and configuration.
- LinkDesk
  Detailed description of the installation, start-up and operation of the LinkDesk software.

Connecting the L 6000 to a network

You can monitor and control one or more L 6000s via a network connection using the Sennheiser Wireless Systems Manager (WSM) software.

The network does not have to be a homogeneous network including only chargers. You can integrate the L 6000 into your existing network infrastructure with any other types of devices.

To connect the L 6000 to a network:

Connect a network cable with an RJ-45 connector (Cat5 at minimum) to the Ethernet socket on the rear side of the L 6000.

For more information about controlling devices via the Sennheiser Wireless Systems Manager (WSM) software, refer to the instruction manual for the software. You can download the software here:

sennheiser.com/wsm