Pairing

The transmitter and the receiver of a set are pre-paired at the factory and therefore ready for immediate use. The wireless connection is established once the transmitter and receiver are switched on and within range of each other.

You can pair up to four transmitters with the receiver. However, you can only use one transmitter with the receiver at a time. The other paired transmitters must be switched off during this time.

  1. Make sure that both the transmitter and receiver are switched off.
  2. Press and hold the pedal switch on the receiver.
  3. Connect the receiver to the power supply system while continuing to hold the pedal switch until a “P” appears on the display.
    The LED will also begin to flash red and green in alternation.

  4. Press the button on the transmitter and the button on the receiver until the status LEDs start flashing green and red in alternation.
    The status LEDs will remain green once the transmitter and receiver are paired and connected. If the status LEDs do not remain green, the charge level is below 15 % (see Checking the charge level during use).