Version 1.1.0

New features

SEK
  • Added Egypt country information to zone 14
  • Added Mexico country information to zone 14
  • Added audio improvement to mic/line path for better microphone and instrument compatibility
Spectera WebUI
  • Added connection loss detection with automatic reconnect
  • Detect version mismatch to Base Station and trigger automatic page reload
  • Added failure log information and reset possibility

Improvements

Base Station
  • Added e-label to zone 5 (South Africa)
  • Added e-label to zone 14 (Mexico)
  • Make notifications acknowledgeable and reappearing, rotation through active notifications
  • Add additional data to system information export
SEK
  • Microphone input is muted, when no microphone is plugged in
  • Reduced display updates when charging in CHG 70N-C
  • Measures the impedance with an inaudible test tone
Spectera WebUI
  • Added Audio Link Mode tables as tooltips
  • Better drop-down visibility in Firefox
  • Factory reset hint added to password dialog
  • Improved headphone plug state
  • Increased contrast of checkboxes for better visibility
  • Removed peak traces from small RF scan
  • Renamed “Support Info” to “Diagnostic Report”
  • Replaced “Audio Net” and “Audio Network” by dynamic name (e.g. “Dante®”)
  • Show RF mute switch in yellow, if RF is muted and at least one antenna is binded to this RF channel
  • Sorted Audio Link Modes within drop-down fields according to datasheet
  • Stored selected color theme within local storage

Bug fix

Base Station
  • Changed display dim time to 2 minutes and display off time to 20 minutes
  • Fixed status LED lighting up yellow during standby mode on RF property change
  • Dante not working after wakeup from standby
SEK
  • Inverted mic input phase

Known issues

Base Station
  • Sometimes Base Station reboots are encountered, if RF channels are muted over the Base Station UI (i.e. from the front panel of the Base Station)
  • RF power is set to a minimum after factory reset
  • Unable to set Audio Link Modes via LinkDesk after successful Base Station and mobile devices firmware update.

    Workaround: Do not use the Spectera WebUI and LinkDesk in parall during Base Station firmware update

SEK
  • Simultaneous bidirectional use cases might impact the noise floor on the mic/line input of the bodypack
  • No low battery warning on device
  • MIC/Line input - noise may occure in the audio signal when instrument cables and microphones have insufficient shielding
  • FCC ID is missing for Canada license on the SEK display
  • One SEK sometimes shows LQI = 2 when switching to 536 MHz
  • The LED colour is red while charging
Spectera WebUI
  • The Spectera WebUI freezed on Safari after macOS went into locked screen
  • Overlap of RSSI min and dominant antenna