Home
User manual
Detailed description of the start-up and operation of your selected hardware and software product.
WebUI
Detailed description of the WebUI navigation and configuration.
Basic configuration
Start your basic configuration with the recommended steps.
Selecting the Mic/Line input
You can select the audio input as signal source for your Mic/Line link.

User manual
Detailed description of the start-up and operation of your selected hardware and software product.
- Network & Security Guide
  This document is intended for IT administrators, system integrators and event technicians and serves as an planning and configuration guide for integrating components of the Spectera offering into diverse network environments from small home networks up to enterprise networks.
- Spectera
  Detailed description of the start-up and operation of your selected hardware.
- WebUI
  Detailed description of the WebUI navigation and configuration.
  - Get started
    Starting the WebUI for the first time, including device authentication and license entitlement.
  - Resetting device password
    You can reset the assigned device password on your Base Station to its factory settings.
  - Basic configuration
    Start your basic configuration with the recommended steps.
    - Activating license
      Under Entitlement, you can enter and activate the current license for the frequency spectrum.
    - Enabling/disabling data collection
      Spectera collects operational data to enhance stability and functionality.
    - Scanning RF frequency
      You can run a frequency scan to check the current frequency situation in your surrounding area.
    - Assigning an antenna for RF channel
      You can choose between up to four connected antennas to assign them to your two possible RF channels.
    - Pairing/unpairing mobile devices
      In the WebUI, you can pair up to 128 mobile devices to a Base Station within one RF channel.
    - Selecting audio link mode (Mic/Line)
      You can select the audio mode for your Mic/Line link.
    - Selecting audio link mode (IEM)
      You can select the audio mode for your IEM link.
    - Assigning RF channel
      You can assign an configured RF channel to your mobile device.
    - Selecting the Mic/Line input
      You can select the audio input as signal source for your Mic/Line link.
  - Configuration
    Under Configuration, you can set the essential settings for the RF channel, antenna, Base Station and mobile devices.
  - Frequency Scan
    You can use an RF scan to examine the current frequency situation of your connected antenna.
  - Audio Levels
    Under Audio Levels you can monitor all interfaces at a glance.
  - Audio inputs and outputs
    Here you have an overview of all channels at a glance and can assign the audio network input and output for the link channels directly and easily.
- LinkDesk
  Detailed description of the installation, start-up and operation of the LinkDesk software.

Selecting the Mic/Line input

You can select the audio input as signal source for your Mic/Line link.

For a smooth system configuration, we recommend first selecting the link modes and afterwards assigning the channels:

You can route audio links to several channels. Routing can be done easily via the routing matrix (see Audio inputs and outputs).

The following input signals are available:

Auto (unknown)
Mic
Line

To choose the audio input:

In the top bar, navigate to Configuration > Mobile Devices > Mic Settings.
Select the audio input from the drop-down list Mic/Line.

The audio input has been selected.